Posts: 2,885
Thanks received: 528
Thanks given: 546
Joined: Oct 2009
Posts: 2,885
Thanks received: 528
Thanks given: 546
Joined: Oct 2009
Ok, the fitting for the pump does NOT unscrew. It’s connected to the knot bladder. The stainless steel cap looks glued as well, or it could be molded to it.
The tip is stainless but it’s the same as the metal tip on one of my catheter . So there is a flexible tube running the length of the dildo.
Now, how to connect a base.
A strip of stainless steel, like we used at Tollyboy, can be connected by a set of #6 stainless steel screws. This will work unless the end cap comes off.
As for the size? I should have picked one size smaller.
Maybe I’ll buy another.
By the way, I love the case it came in.
Posts: 26,039
Thanks received: 12984
Thanks given: 6967
Joined: Jul 2006
Is the whole construction flexible? At what angle (approximately) can you bend it?
Posts: 2,885
Thanks received: 528
Thanks given: 546
Joined: Oct 2009
I can pretty much bend it 75 degrees.
Not quite 90. 45 seems the safest.
Tried it a
eady. Actually, it slides in very easily. Once I inflate it 6 pumps, it does hold its position.
And, at 8 pumps, it’s not coming out. For me that is.
And I found no red spots after removal.
You can’t sit with it, but you can walk around if you have on a skirt on.
Posts: 1,285
Thanks received: 647
Thanks given: 962
Joined: Nov 2013
(31 Oct 2020, 00:05 )Tinker D Wrote: Tried it aeady. Actually, it slides in very easily. Once I inflate it 6 pumps, it does hold its position.
And, at 8 pumps, it’s not coming out. For me that is.
and no indication of it wanting to "walk" further in?
Is the silicone just above the steel collar flexible? as in this is where you clamp down on?
Posts: 2,885
Thanks received: 528
Thanks given: 546
Joined: Oct 2009
31 Oct 2020, 13:56
(This post was last modified: 31 Oct 2020, 15:01 by Like Ra.)
No. The base towards the knot is pretty much solid. But after the knot, it does bend. It not soft and squishy like the dildos we see that can be pushed out by squatting and pushing. And, it is not straight. It’s tapered.