31 Aug 2015, 15:41
Ok, I think I have solved this chair dildo idea. And the parts are cheap and can be very well hidden too. I'll have pictures this week.
Here is what you'll need. 1 1/4 inch connecting nut, 3 1/4 standard nuts, a 6 inch bolt with the head cut off. Your air cylinder with a 6-7 inch throw and 2 metal brackets.
The first bracket can be found at almost any lumber yard. It is "U" shape and long. A hole in the bottom of the "U" is where the air cylinder bolts on. The 1/4 inch shaft from the cylinder has one nut screwed all the way in. The other peice of metal is a flat plate with 4 holes in it. One hole fits over the air cylinder, down to the nut. The connecting nut is then threaded on, locking the small bracket to the air cylinder.
The 6 inch bolt with the head cut off is also bolted in the same way to the small bracket. This the key release part. The key to this assembly is that the long bolt from the small bracket must clear the "U" shape bracket so that the ring on your key string is released. So, once the air cylinder is extended all the way out, the release pin is pulled all the way out and the ring is free to drop the keys.
This assembly is then screwed to a peice if wood that bolted to the base of the chair. A knot hole in the chair is where the dildo or butt plug goes.
How does the dildo connect to the cylinder? Mount a 1/4 inch bolt in the dildo and thread it into the connecting nut on the air cylinder.
And that's how it's done.
Any questions?
Here is what you'll need. 1 1/4 inch connecting nut, 3 1/4 standard nuts, a 6 inch bolt with the head cut off. Your air cylinder with a 6-7 inch throw and 2 metal brackets.
The first bracket can be found at almost any lumber yard. It is "U" shape and long. A hole in the bottom of the "U" is where the air cylinder bolts on. The 1/4 inch shaft from the cylinder has one nut screwed all the way in. The other peice of metal is a flat plate with 4 holes in it. One hole fits over the air cylinder, down to the nut. The connecting nut is then threaded on, locking the small bracket to the air cylinder.
The 6 inch bolt with the head cut off is also bolted in the same way to the small bracket. This the key release part. The key to this assembly is that the long bolt from the small bracket must clear the "U" shape bracket so that the ring on your key string is released. So, once the air cylinder is extended all the way out, the release pin is pulled all the way out and the ring is free to drop the keys.
This assembly is then screwed to a peice if wood that bolted to the base of the chair. A knot hole in the chair is where the dildo or butt plug goes.
How does the dildo connect to the cylinder? Mount a 1/4 inch bolt in the dildo and thread it into the connecting nut on the air cylinder.
And that's how it's done.
Any questions?
