18 Sep 2022, 04:59
Hello guys !
It has been a long time 😊
Well, guess what, I remembered how much I loved vacuum bondage, and now I live alone, I thought it would be a good idea to show how easy and cheap you can get into vacuum bondage.
Last night, I built something using a few materials, and here, I'll explain how I did it...
So, for those who knows the store «Canadian Tire», I bought a plastic drop sheet, which is 8 ft x 12 ft. around $7 CDN
Then, I folded it to get a 8 ft. x 6 ft. piece, and I used some duct tape to join the two edges together. The offset is about 1 inch (2,5 cm) between the top layer and the bottom layer, as shown here:
For the last part, I duct taped the bottom like this:
So once the bag is ready, you need a mattress (of course, slightly smaller than the bag ! (about 6ft x 4 ft. would be nice):
For those wanting to activate the vacuum from inside, you might need a hand switch like this:
Finally, you must seal the vacuum hose and the switch once again with duct tape. It is important to put the end of the vacuum facing the mattress, so the air could be sucked out passing by the mattress. That will allow all the air to be evacuated:
Here is the result:
So I tried it, and the result is absolutely stunning and nice !
Thanks for reading, and if you have some questions, feel free to write a comment 😊 !
vacuum_experiments
It has been a long time 😊
Well, guess what, I remembered how much I loved vacuum bondage, and now I live alone, I thought it would be a good idea to show how easy and cheap you can get into vacuum bondage.
Last night, I built something using a few materials, and here, I'll explain how I did it...
So, for those who knows the store «Canadian Tire», I bought a plastic drop sheet, which is 8 ft x 12 ft. around $7 CDN
Then, I folded it to get a 8 ft. x 6 ft. piece, and I used some duct tape to join the two edges together. The offset is about 1 inch (2,5 cm) between the top layer and the bottom layer, as shown here:
For the last part, I duct taped the bottom like this:
So once the bag is ready, you need a mattress (of course, slightly smaller than the bag ! (about 6ft x 4 ft. would be nice):
For those wanting to activate the vacuum from inside, you might need a hand switch like this:
Finally, you must seal the vacuum hose and the switch once again with duct tape. It is important to put the end of the vacuum facing the mattress, so the air could be sucked out passing by the mattress. That will allow all the air to be evacuated:
Here is the result:
So I tried it, and the result is absolutely stunning and nice !
Thanks for reading, and if you have some questions, feel free to write a comment 😊 !
vacuum_experiments