Like Ra's Naughty Forum

Hello guys !

It has been a long time 😊

Well, guess what, I remembered how much I loved vacuum bondage, and now I live alone, I thought it would be a good idea to show how easy and cheap you can get into vacuum bondage.

Last night, I built something using a few materials, and here, I'll explain how I did it...

So, for those who knows the store «Canadian Tire», I bought a plastic drop sheet, which is 8 ft x 12 ft. around $7 CDN
[attachment=56038]

Then, I folded it to get a 8 ft. x 6 ft. piece, and I used some duct tape to join the two edges together. The offset is about 1 inch (2,5 cm) between the top layer and the bottom layer, as shown here:
[attachment=56040][attachment=56039]

For the last part, I duct taped the bottom like this:
[attachment=56041]

So once the bag is ready, you need a mattress (of course, slightly smaller than the bag ! (about 6ft x 4 ft. would be nice):
[attachment=56042][attachment=56043]

For those wanting to activate the vacuum from inside, you might need a hand switch like this:
[attachment=56045]

Finally, you must seal the vacuum hose and the switch once again with duct tape. It is important to put the end of the vacuum facing the mattress, so the air could be sucked out passing by the mattress. That will allow all the air to be evacuated:
[attachment=56044][attachment=56046]

Here is the result:
[attachment=56047]

So I tried it, and the result is absolutely stunning and nice !
[attachment=56048]

Thanks for reading, and if you have some questions, feel free to write a comment 😊 !

vacuum_experiments

Wow, that just gave me a solution to an arcade problem we have been struggling for years.
And I like the results of your vacuum bed.
Question???
How did you breathe ??? Don’t see a hose.

(18 Sep 2022, 16:43 )Tinker D Wrote: [ -> ]How did you breathe ??? Don’t see a hose.

Was just about to ask the same question.

Maybe he used a snorkel with a hose attached???

When you zoom in, I think there is a fairly thin hose to the left side of his head inside the sheathing.

(18 Sep 2022, 16:43 )Tinker D Wrote: [ -> ]Wow, that just gave me a solution to an arcade problem we have been struggling for years.

I don't want to derail the thread but I'm legitimately curious how a home made vacbed has helped you solve a years long arcade problem.

(19 Sep 2022, 04:23 )essanym Wrote: [ -> ]

(18 Sep 2022, 16:43 )Tinker D Wrote: [ -> ]Wow, that just gave me a solution to an arcade problem we have been struggling for years.

I don't want to derail the thread but I'm legitimately curious how a home made vacbed has helped you solve a years long arcade problem.

Probably how to protect the floor of the arcade. Using plastic drop sheets maybe? Either that or covering something else

That’s for another thread.
Not going to hijack this one, No sir-e Bub.
Not going to happen.

(18 Sep 2022, 16:43 )Tinker D Wrote: [ -> ]Wow, that just gave me a solution to an arcade problem we have been struggling for years.
And I like the results of your vacuum bed.
Question???
How did you breathe ??? Don’t see a hose.

Hello Tinker D,

I'm glad you like the result 😊

So I breathe thanks to a very small hole I punched with my teeth while the vacuum was pressing me on the mattress.

Have a nice day !

vacuum_experiments

Here is a gif of the vac mattress in action, for those interested to see !

[attachment=56095]