I wanted a scenario with everything; deepthroating, nipple torture, piss drinking, forced cumming and a vibrating butt plug. Of course there can be more, but this was complicated enough.
The biggest problem was how to get my release by deepthroating. First I fastened the dildo on a bar clamp, at the end pointing out. On the same bar clamp there are two switches, one above the dildo for my nose and one below for my chin. The ground is wired through both switches in serial, so both switches must be pressed in order for the ground to go through.
I sit on a kitchen chair and I have a MagBound® Handpillory bolted to the back of it. The handpillory is really great, but when ordering it I made a mistake. I ordered a too small size and had to grind them out, but now they fit my wrists perfectly.
I measured wrong, you should read the instructions.
The release system runs on 12 volts. I have a mechanical 12v timer witch get constant 12v and when it gets ground from the dildo switches the clock starts turning. It is easy to set the amount of time with the mechanical clock. When the clock has turned enough, the timer lets 12v go through. Then what to do with the 12v to get the release?
The MagBound® Smart Timer controls the pillory and the USB cord on it has only 2 cores, ground and 5v. I have cut it open and the ground now goes through a 12v 5 pole relay. If the relay does not get both 12v and ground, it lets the ground go through. The relay gets 12v all the time, and it gets the ground from the mechanical timer when I have deepthroated for long enough. Then the pillory releases my wrists.
The same ground which starts the clock also controls my vibrating butt plug and dick head vibrator. So when I deepthroat I get stimulated/tortured.
These could be separated, so a timer would decide when they work, but I went this route for now.
I really love nipple torture, but no matter how cruel clamps I use I get used to them and after a while they do not do much anymore. Weights do not help if they just hang there, they would have to move and bounce around. I have used a timed window viper motor before, but this time I tried a central locking motor to pull the piercings in my nipples. The piercings are better to use than clamps because when not pulled there is no pain so you do not get used to it. There is a timer for the motor too and it pulls once every 3 minutes. The pull is only about 1 inch, so there must not be any slack in the line. The way I sit with the pillory behind my back, there is no leaning forward to ease the pain.
For the piss/cum I have a hollow penis plug which leads to a t-fitting. In front of me, there is an enema bag filled with my first morning piss. Maybe 3dl. On the floor there is a liquid soap pump. There are no batteries in it, it gets the needed voltage and ground from its own timer. 20 seconds every 2 minutes. It has no problem pumping the dildo in my mouth and I have to swallow, or I make a mess.
First run I had only 5 minutes to deepthroat and the butt plug did not work, but otherwise it was a success.
Everything worked, but the pump was too slow. It took too long to drink all the piss. When the piss was gone I let myself orgasm, but just as I came the time was up, and I was free. I wanted to get the taste of my cum.
Next time the pump will be faster, more voltage, from 3 to 4.5. And the nipple pull will be more frequent, there was a little slack too, so I shorten the line. A vibrating prostate massager will also be "there".
I have not mentioned emergency release, but I have one. There are a ton of boring details I left out, if you have questions, just ask. I will try my best to answer, although English is not my mother tongue. My advice is to test everything carefully, so there are no surprises when you start your session.
(This post was last modified: 05 Nov 2024, 22:06 by Like Ra.)
The biggest problem was how to get my release by deepthroating. First I fastened the dildo on a bar clamp, at the end pointing out. On the same bar clamp there are two switches, one above the dildo for my nose and one below for my chin. The ground is wired through both switches in serial, so both switches must be pressed in order for the ground to go through.
I sit on a kitchen chair and I have a MagBound® Handpillory bolted to the back of it. The handpillory is really great, but when ordering it I made a mistake. I ordered a too small size and had to grind them out, but now they fit my wrists perfectly.
I measured wrong, you should read the instructions.
The release system runs on 12 volts. I have a mechanical 12v timer witch get constant 12v and when it gets ground from the dildo switches the clock starts turning. It is easy to set the amount of time with the mechanical clock. When the clock has turned enough, the timer lets 12v go through. Then what to do with the 12v to get the release?
The MagBound® Smart Timer controls the pillory and the USB cord on it has only 2 cores, ground and 5v. I have cut it open and the ground now goes through a 12v 5 pole relay. If the relay does not get both 12v and ground, it lets the ground go through. The relay gets 12v all the time, and it gets the ground from the mechanical timer when I have deepthroated for long enough. Then the pillory releases my wrists.
The same ground which starts the clock also controls my vibrating butt plug and dick head vibrator. So when I deepthroat I get stimulated/tortured.
These could be separated, so a timer would decide when they work, but I went this route for now.
I really love nipple torture, but no matter how cruel clamps I use I get used to them and after a while they do not do much anymore. Weights do not help if they just hang there, they would have to move and bounce around. I have used a timed window viper motor before, but this time I tried a central locking motor to pull the piercings in my nipples. The piercings are better to use than clamps because when not pulled there is no pain so you do not get used to it. There is a timer for the motor too and it pulls once every 3 minutes. The pull is only about 1 inch, so there must not be any slack in the line. The way I sit with the pillory behind my back, there is no leaning forward to ease the pain.
For the piss/cum I have a hollow penis plug which leads to a t-fitting. In front of me, there is an enema bag filled with my first morning piss. Maybe 3dl. On the floor there is a liquid soap pump. There are no batteries in it, it gets the needed voltage and ground from its own timer. 20 seconds every 2 minutes. It has no problem pumping the dildo in my mouth and I have to swallow, or I make a mess.
First run I had only 5 minutes to deepthroat and the butt plug did not work, but otherwise it was a success.
Everything worked, but the pump was too slow. It took too long to drink all the piss. When the piss was gone I let myself orgasm, but just as I came the time was up, and I was free. I wanted to get the taste of my cum.
Next time the pump will be faster, more voltage, from 3 to 4.5. And the nipple pull will be more frequent, there was a little slack too, so I shorten the line. A vibrating prostate massager will also be "there".
I have not mentioned emergency release, but I have one. There are a ton of boring details I left out, if you have questions, just ask. I will try my best to answer, although English is not my mother tongue. My advice is to test everything carefully, so there are no surprises when you start your session.
