3d printed self bondage.

I bought a second-hand set of 3D-printed bondage mitts – with an opening system where you have to insert something to open them. So that is awkward when both hands are inside, and I am looking for ideas to make it simpler for self-bondage.

Does anyone have an idea?

telegram @latexslaafboy

They look like fun! I have a similar pair. I sometimes use an lice lock to chain myself to a place I can access tool them out them on. I'm stuck until the ice lock folding the chain releases and I can reach tools.

Doing it with a gag on is fun because your hands are useless, so you can't unbuckle straps.

They look like fun! I have a similar pair. I sometimes use an lice lock to chain myself to a place I can access tool them out them on. I'm stuck until the ice lock folding the chain releases and I can reach tools.

Doing it with a gag on is fun because your hands are useless, so you can't unbuckle straps.

thanks for your replay 
But my question is how do I get out of it if my hands are unusable, my mouth is gagged, and I have to put a pen or tool in the hole?

Tape a screwdriver or something to a chair, make sure it's definitely secure so you can use that to get out. Tape a few around the house in case one fails.

Good ideas from Anne (as usual!). Having lots of options around is a good idea. I often use my feet also. Lots of fun! Can't wait for my next play time now!

[Like Ra]

Tape a screwdriver or something to a chair

Or, better, use a table mounted small vice to fix the screwdriver in place.