Kinky devices test

[essanym]

Can you tell us which improvements you made? I'm also building such an automated feeding machine and would be very happy

My device uses proprietary 3d printed parts. Air was leaking in those parts where it should have been sealed so i added some silicone sealant where needed to prevent that from happening. Also adjusted the tubing placement at the source end.

Would love to hear about your feeding machine.

[schulz]

Can you tell us which improvements you made? I'm also building such an automated feeding machine and would be very happy

My device uses proprietary 3d printed parts.  Air was leaking in those parts where it should have been sealed so i added some silicone sealant where needed to prevent that from happening.  Also adjusted the tubing placement at the source end.

Would love to hear about your feeding machine.

Thank you very much. Mine is built out of two containers holding each mac. 2L of fluid, connected by a pump. The top container is placed higher then the head and is connected to a pump up gag, the bottom container lower then my cock. This one is connected with a latex sheath with tube. So when the pump is pumping the liquid in the upper container it runs through the hose into my gag. When pissing/ cum in the sheath it flows into the bottom container, the pump brings it again to the upper one. This whole system is controlled by an ESP32 Webcontrol by my Mistress during watching me via Cam