Hello everyone, it has been a while since I posted a session. Would love to hear any feedback on this one. For safety I did not fully lock myself into this one, all I needed to do was unbuckle the cuffs. I also implemented my method of removing a support stool for suspension sessions. You basically use a pair of tights tide to a secure structure and when you remove your weight gone is the stool. You can't see them but I am wearing my lovely ballet boots and have four stockings in my mouth as a gag.
[
attachment=51939]
[
attachment=51940]
[
attachment=51941]
[
attachment=51942]
[
attachment=51943]
I like your idea as well as your outfit.
But what problems have you encountered and what are you going to next ?
(12 Dec 2021, 19:23 )Tinker D Wrote: [ -> ]I like your idea as well as your outfit.
But what problems have you encountered and what are you going to next ?
Thanks Tinker D. I also love the outfit, most of the fun really. The only problem I had was that most of the weight was taken by the thigh attachments rather than ankles. I’d likely adjust the ropes to also leave me a bit higher. Could add some more spots to support my weight. Next time I might actually lock the cuffs on and run the keys on a string to a kitchensafe. Do you have any suggestions?
Many years ago, I did suspension I found on a website. Sadly, the site is gone as well as the pictures.
What I did was to wrap about 6 turns of rope around my chest, above me boobs, through a 2 inch ring.
I did a similar one around my waist, also through a 2 inch ring.
Because all the loops of rope went through the steel rings, the can not tighten themselves around your body.
I use leather cuffs for the wrists and ankles.
I had a beam that I used for suspension. It went like this.
The beam has several turns of rope wrapped around it an a 2 inch steel ring. On eather side of this are eyelets, about 3 feet away from center.
I start by threading a rope from each eyelet to my ankle cuffs and let the free ends hang free. Or I tie the two ends loosely together so I can track them later.
Add toys now for more fun.
I then tie a rope from the center ring and run it through the ring on the top chest ropes. I normally do 3 loops and then pull tight. Standing on tipy toes helps. I then thread the rope to the waist ring in the same manner and after taken out the slack, tie it off.
Now the ankles.
I forgot that also use a waist belt or a pair of thigh straps for this part.
Take the free end of one ankle rope and pull. This will pull your ankle up and away. Tie that rope off to your thigh or waist belt.
Do the same to the other ankle rope.
Now, your off the ground. Turn on your toys and secure your wrists.
I would suggest you try this first without biding your hands. Make adjustments and do again.
I was able to last an hour or so before my release kicked in.
(12 Dec 2021, 20:35 )Tinker D Wrote: [ -> ]Many years ago, I did suspension I found on a website. Sadly, the site is gone as well as the pictures.
What I did was to wrap about 6 turns of rope around my chest, above me boobs, through a 2 inch ring.
I did a similar one around my waist, also through a 2 inch ring.
Because all the loops of rope went through the steel rings, the can not tighten themselves around your body.
I use leather cuffs for the wrists and ankles.
I had a beam that I used for suspension. It went like this.
The beam has several turns of rope wrapped around it an a 2 inch steel ring. On eather side of this are eyelets, about 3 feet away from center.
I start by threading a rope from each eyelet to my ankle cuffs and let the free ends hang free. Or I tie the two ends loosely together so I can track them later.
Add toys now for more fun.
I then tie a rope from the center ring and run it through the ring on the top chest ropes. I normally do 3 loops and then pull tight. Standing on tipy toes helps. I then thread the rope to the waist ring in the same manner and after taken out the slack, tie it off.
Now the ankles.
I forgot that also use a waist belt or a pair of thigh straps for this part.
Take the free end of one ankle rope and pull. This will pull your ankle up and away. Tie that rope off to your thigh or waist belt.
Do the same to the other ankle rope.
Now, your off the ground. Turn on your toys and secure your wrists.
I would suggest you try this first without biding your hands. Make adjustments and do again.
I was able to last an hour or so before my release kicked in.
This idea sounds amazing and I wish I had a beam like you describe, as well as a vertical one for pole ties while mentioning it. Do you have any photos of this when you tried it?
No, everything got lost in the 2018 fire.
But you can do what I did on your hotel cart.
Send me a picture of the cart. I’ll see what I can come up with.
(12 Dec 2021, 22:02 )Tinker D Wrote: [ -> ]No, everything got lost in the 2018 fire.
But you can do what I did on your hotel cart.
Send me a picture of the cart. I’ll see what I can come up with.
Sorry to hear that. Hope you’ve been able to rebuild since then. It is a pretty standard cart with two bars on the side for extra attachment points.
Yea, and your pictures won’t load.
&😉;;$&😉😢 wheel just keeps on spinning.
The images are very big - it takes time to load them.
I found the pictures. No discription, but the whole set.
It’s here on this site. Or you can google it under “ self bondage suspension “
Going to do this again in my new romper, if it gets here.