+- Like Ra's Naughty Forum (https://www.likera.com/forum/mybb)
+-- Forum: Bondage (https://www.likera.com/forum/mybb/Forum-Bondage)
+--- Forum: Bondage General (https://www.likera.com/forum/mybb/Forum-Bondage-General)
+--- Thread: What valve is used on this video! (/Thread-What-valve-is-used-on-this-video)
Pages:
1
2
RE: What valve is used on this video! - Like Ra - 16 Jul 2016
(16 Jul 2016, 15:25 )Like Ra Wrote: 12v 1/2" N/O valve
I think only this one will work, because of the real internal diameter. It's 2.5mm for the first two, and 16mm for this one.
RE: What valve is used on this video! - xerof - 18 Jul 2016
I ended up getting this one at the end: 1/2" 1" DC12V Motorized Ball Valve
3/4 inch CR02 wiring. I had a little play about last night with a TENS machine hooked up (had company during the night so the hitachi wasn't an option) so will play about with the hitachi one night soon 😊
I like the noise of this because it means a build up that you know what's about to come next. I would like to add in some variables like every minute there's a x% chance that it may hold your breath for you (as long as there was like 30 seconds since the previous hold) with a random amount of time it will hold. Maybe even be cruel and still keep what ever is attached still going but again based on a x% chance of this happening.
I have a few plans of maybe hooking up some electrodes in certain places, and using a relay to operate a random one depending on either while the breath is being held... I'm not too sure.
Would be awesome to be able to control the ET312 via the arduino to increase the power, and be able to ramp it back up when you release the button.
RE: What valve is used on this video! - Like Ra - 18 Jul 2016
Will 8mm be enough to breath through?
RE: What valve is used on this video! - xerof - 18 Jul 2016
It's actually 15mm in the middle. I've seen people with trachea's which are 6mm in size and breathe fine (just a little more resistance?)
RE: What valve is used on this video! - Like Ra - 18 Jul 2016
(18 Jul 2016, 18:57 )xerof Wrote: It's actually 15mm in the middle.What is labelled as 8mm then? I thought that 15 mm is the diameter of the opening of the "chamber" where the ball rotates, but the hole in the ball is 8mm. At least this is my understanding.
RE: What valve is used on this video! - xerof - 18 Jul 2016
Ahh I see, that's the three port. I got the two port. I didn't see that picture!