![]() |
|
Suspension self-bondage - Printable Version +- Like Ra's Naughty Forum (https://www.likera.com/forum/mybb) +-- Forum: Self-Bondage (https://www.likera.com/forum/mybb/Forum-Self-Bondage) +--- Forum: Self-Bondage Techniques (https://www.likera.com/forum/mybb/Forum-Self-Bondage-Techniques) +--- Thread: Suspension self-bondage (/Thread-Suspension-self-bondage) |
RE: Suspension self-bondage - Like Ra - 14 Jan 2017 EBay showed me this picture from Kinbaku Comic book, and I think that this semi-suspension "configuration" can be used in self-bondage. Or at least, a part of it. My idea of semi-suspension is when there is a rope going from somewhere above to the ropes binding a person, so a part of the body is suspended, OR will be suspended should the person move from the current position, thus gently returning him/her back. RE: Suspension self-bondage - hopeender - 16 Feb 2017 (30 Jun 2016, 09:39 )Like Ra Wrote: Another semi-suspension variant that should work for self-bondage: I've always thought of something like this picture but have something like a pile of clothes or pillows to lay on top of, then as you wiggle the pillows scatter leaving you a couple of inches off the ground. RE: Suspension self bondage - Tinker D - 26 Jun 2026 (04 Feb 2012, 01:41 )Tinker D Wrote: OK, I think I got a good one for you and I do beleve that it is safe for a few hours or so. The idea came to me one day while researching a good Suspension. I have sent the pages to Li Kera so I will not tell you about the tie. But, here is how I can see it work. A while back, I was talking about self bondage suspension. And we uploaded an article from Bondage Life called upsey Daisy, one more time. One of the problems with this tie was the metal pipe to stand on. Wood, dowel, even a leather strap for the feet and ankles. Hmmm….. leather strap… Maybe leather stirrups, like those on saddles. These may just work. So, take a pair of stirrups from a saddle, tie your main suspension rope to them and then slip your feet into them. Then continue with your tie like before and enjoy the ride. I think works a lot better than a steel or PVC pipe or a 1.75 inch wood dowel. RE: Suspension self-bondage - Tinker D - 26 Jun 2026 Thinking about this again, I just remembered about another problem doing this tie. A number of houses do not have any anchor points for suspension of anything over 10lbs. Ones who have a rather large walk-in closet can install a beam between the walls. But those of us who don’t have a walk-in closet are pretty much screwed. So, what would you do ?? RE: Suspension self-bondage - madjack - 26 Jun 2026 (26 Jun 2026, 16:39 )Tinker D Wrote: Thinking about this again, I just remembered about another problem doing this tie. I've seen a number of bondage shoots where there is a three or four legged frame that looks to be portable, using webbing straps on the floor to tension the legs against each other. I shall try to find some images to demonstrate better than my words! One of these could work, though I guess you'll need high ceilings and a big enough space to set the frames up. I'd actually considered using a garden swing frame indoors, but could only find the types that required either too much height (9-10ft or over 3m) or where not easily assembled/de-assembled indoors. MJ RE: Suspension self-bondage - madjack - 26 Jun 2026 (26 Jun 2026, 17:32 )madjack Wrote:(26 Jun 2026, 16:39 )Tinker D Wrote: Thinking about this again, I just remembered about another problem doing this tie. Here you go, something along these lines perhaps? Search Amazon for "Portable Hammock Stand Heavy-Duty Steel A-Frame for Aerial Yoga Swing Acrobatic Dance Fitness with Exercise Ring Suspension Kit" or just search for 'indoor suspension frame'. Claimed to be good for over 500lbs (+200kg) but the height is only188cm (74") Anyway, that's what I was thinking about MJ RE: Suspension self-bondage - Tinker D - 26 Jun 2026 Something a bit morel decorative, like remodeled a spare room or bedroom to give it a more European look. That could some tie points. But your picture reminds me of a shop engine hoist. Yea, I don’t think it’s tall enough. Hard to hide or blend in. But thank you |