Forced deep throat

[Like Ra]

Speaking of sizes, dildos and deepthroating abilities. We need more training:



(it's an animated GIF)

[catransvestic]

(31 Jan 2012 02:51 )Like Ra Wrote:  Speaking of sizes, dildos and deepthroating abilities. We need more training:



(it's an animated GIF)

It's good to have goals in life..

[Like Ra]

(01 Feb 2012 00:10 )catransvestic Wrote:  It's good to have goals in life

I would rephrase to "It's good to have fun in life" ;-)

[whiteangel]

Hi LikeRa,

I did some viability test to see if the photosensor inside a translucent plastic toy would work for detecting a deep throat. I would dare to tell it would!
The experiment consisted in sticking a photo camera lenses down the barrel of an emptied translucent toy, and take a series of pics inside a normally lit room (no spotlights). Here are the results:

- toy alone
- toy inside the mouth
- toy grabbed by one hand
- toy clamped between your neck and your sholder, like when gripping a phone "handsfree" - about the most you could do to try to put the sensor in a shadow if hands were not available. Simply staning in way of the light creates even less darkening.

You can see that the inside of the mouth is way darker than any other try - it would be no problem to set the lighting threshold to distinguish it
You could also tweak the depth required by placing the sensor further or nearer down the barrel.
So, the method is likely to work in my conclusion...

[Like Ra]

(01 Feb 2012 14:09 )whiteangel Wrote:  Here are the results:

The results look like either hard pr0n or medical investigation
What a scientific approach!

I assume calibration will require lots of test deepthroating ;-P

What for toy did you use, BTW?

[whiteangel]

(01 Feb 2012 15:16 )Like Ra Wrote:  What a scientific approach!

Hey, we are dealing with serious issues here, arn't we?

(01 Feb 2012 15:16 )Like Ra Wrote:  What for toy did you use, BTW?

A quite basic common model, described as "beige rubber vibrator", simmilar to this one:



The black plastic battery container is glued only on the edge, cutting around wit knife on the line of contact with beige rubber will allow to remove the battery container and the motor can.

Cheers!

[Marcus]

(01 Feb 2012 15:16 )Like Ra Wrote:  What a scientific approach!

Brilliant !!!
Maybe the dark area would be a constant temp in the IR spectrum and very close to core body temp unlike the hands ?

[Like Ra]

OK, the next question is how to reliably mount a dildo to something unmovable.

[whiteangel]

(02 Feb 2012 04:15 )Like Ra Wrote:  OK, the next question is how to reliably mount a dildo to something unmovable.

Depends where it should be anchored...

Once the photosensor is in, you could actually glue back in the removed battery container, ans use it for fixing.

This may be an overkill, but would work on a metal bed frame, and could look cool, depends on your taste:



(From http://www.materialesnavarro.es)

However, the whole point is that you should not be able to untie/unscrew it by yor teeth, so just using nylon cable ties should be sufficient, and easier to remove when having to stow away your toys in rush

Pitty the MacGyver is not into selfbondage, we could use his help here

Cheers!

[whiteangel]

Here is a new version of the Arduino based kit, with a new feature: a photo resistor.



As outputs, there are still the electromagnet and a the vib.
The software works basically like this:

For each time the sensor is put in shadow and in light again, it gives you 2 points.
Each second, you are discounted one point (if your score is positive).
Basicaly it means that to rack up points, you need to cycle it more than once in two seconds.
While your score is higher tan 50, the vib will run on low revolutions.
If your score reaches 250 points, the vib will run fo 2 minutes full speed, followed by the release of the key (electromagnet powered down).

Sounds like a nice session?

Ps: by the way, it works